Daikin FTYN35DV3B ATY35DV2 Manuel d'installation télécharger pdf (Page 4)

■English 2

Accessories

– ,

*1 The thermistor cable is attached to the indoor unit.

Choosing a Site

• Before choosing the installation site, obtain user approval.

Installation Tips

■

■■

■

How to remove the front panel.

•

Hook fingers on the panel protrusions on the left and right of the main body, and open until the panel stops.

•

Slide the front panel sideways to disengage the rotating shaft.

•

Then pull the front panel toward you to remove it.

■

■■

■

How to attach the front panel.

•

Align the tabs of the front panel with the grooves, and push all the way in.

•

Then close slowly.

•

Push the center of the lower surface of the panel firmly to engage the tabs.

■

■■

■

How to remove the front grille.

•

Open the front panel.

•

Remove the screws (2 pcs) on the front grille.

•

Pull the lower part of the front grille toward you, then remove the front grille completely.

(There are 2 hooks on the upper part.)

If it is difficult to remove, open the front grille and raise the top grid, using a screwdriver,

to unhook the hooks.

■

■■

■

How to attach the front grille.

•

Attach the front grille to the bottom frame, and lock the upper hooks (2points) securely.

•

Tighten the screws (2 pcs) on the front grille.

•

Attach the front panel and close the front panel.

■

■■

■

How to set the different addresses.

•

When two indoor units are installed in one room, the two wireless remote con-

trollers can be set for different addresses.

■

■■

■

PCB in the indoor unit.

•

Remove the front panel.

•

Remove the electric parts box (1-screw).

•

Slide the metalic cover to remove it. (4-claws on the electric parts box)

•

Cut the jumper JA on PCB.

■

■■

■

Wireless remote controller.

•

Cut the jumper J4.

Mounting plate

Remote controller holder

Thermistor cable (8m)*1

Mounting plate fixing screw

M4 × 25L

Fixing screw for remote

controller holder M3 × 20L

Operation manual

Titanium Apatite Photocatalytic

Air-Purifying Filter

AAA dry-cell batteries

Installation manual

Wireless remote controller

Indoor unit fixing screw

M4 × 12L

Drain plug

(Heat pump-Models)

The indoor unit should be sited in a place where:

• the restrictions on installation specified in the

indoor unit installation drawings are met,

•

both air intake and exhaust have clear paths met,

• the unit is not in the path of direct sunlight,

•

the unit is away from the source of heat or steam,

• there is no source of machine oil vapour (this

may shorten indoor unit life),

• cool (heat) air is circulated throughout the room,

• the unit is away from electronic ignition type flu-

orescent lamps (inverter or rapid start type) as

they may shorten the remote control range,

• the unit is at least 1 metre away from any televi-

sion or radio set (unit may cause interference

with the picture or sound).

The outdoor unit should be sited in a place where:

•

the restrictions on installation specified in the outdoor unit installation diagram are met,

• drain water causes no trouble or problem in particular,

• both air intake and exhaust have clear paths of air (they should be free of

snow in snowy districts),

• the unit is in a clear path of air but not directly exposed to rain, strong

winds, or direct sunlight,

• there is no fear of inflammable gas leakage,

• the unit is no directly exposed to salt, sulfidized gases, or machine oil

vapour (they may shorten outdoor unit life),

• operation noise or hot air flow does not cause trouble to neighbours,

• the unit is at least 3 metres away from any television or radio antenna.

•

Turn on all the fluorescent lamps in the room, if any, and find the site where remote

controller signals are properly received by the indoor unit (within 7 metres).

A L

Outdoor unit

A E J

B F

G L

H M

Outdoor unit

Fit the key into the slot.

Filter guide

Screwdriver

Upper grille

Raise and

remove

Hook

Screwdriver

Upper hook

ADDRESS

EXIST 1

CUT 2

ADDRESS: JA

EXIST 1

C31

J30

JP11

ADDRESS

Metallic

cover

Claws (4 point)

Electric

parts

box

PCB

Wireless

remote

controller

01_EN_3P147083-2F.fm Page 2 Friday, October 28, 2005 9:29 AM

1 2 3 4 5 6 7 8 9 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

Daikin FTYN35DV3B ATY35DV2 Manuel d'installation Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Climatiseurs à système divisé Daikin FTYN35DV3B ATY35DV2