Daikin J Series Manuel de service Page 60

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 162
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 59
Si04-115 Instruction
System Configuration 51
11
ATTENTION
Notes on OFF TIMER
NIGHT SET MODE
When the OFF TIMER is set, the air conditioner automatically
adjusts the temperature setting (0.5˚C up in COOL, 2.0˚C down
in HEAT) to prevent excessive cooling (heating) for your
pleasant sleep.
Timer functions are useful for automatically switching the
air conditioner on or off at night or in the morning. You can
also use OFF TIMER and ON TIMER in combination.
1
Press
OFF
while the air conditioner
is operating.
Check that the clock is correct.
If not, set the clock to the present time. (See page 46.)
Press
CANCEL
.
Then the TIMER lamp lights up.
To cancel the timer:
Press
OFF
once again.
Then the TIMER lamp goes off.
OFF TIMER operation
Press
TIMER
until the time setting
reaches the point you like.
Every pressing of either button increases or decreases
the time setting by 10 minutes. Holding down either
button changes the setting rapidly.
2
3
Press
ON
while the air conditioner is
not operating.
Press
ON
once again.
Press
TIMER
until the time setting
reaches the point you like.
Every pressing of either button increases or decreases
the time setting by 10 minutes. Holding down either
button changes the setting rapidly.
ON TIMER operation
1
2
3
Combining ON TIMER and OFF TIMER
A sample setting for combining the two timers is shown below.
Press
CANCEL
.
To cancel the timer:
Then the TIMER lamp goes off.
Then the TIMER lamp lights up.
Check that the clock is correct. If not, set the clock to the present
time (See page 46).
Timer Operation
AM
is displayed.
blinks.
*Previous time setting
appears on display.
AM
is displayed.
blinks.
*Previous time setting
appears on display.
AM
Display
AM
Display
Display
AM
Present time: 11:00 PM
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
Combined
(Example)
Notes on ON,OFF TIMER
When TIMER is set, the present time is not displayed.
Once you set ON,OFF TIMER, the time setting is kept in the
memory. (The memory is canceled when remote controller
batteries are replaced.)
When operating the unit via the ON/OFF Timer, the actual
length of operation may vary from the time entered by the
user.(Maximum approx. 10 minutes.)
AM
Display
ON
OFF
AM
AM
Display
In the following cases, set the timer again.
After a breaker has turned OFF.
After a power failure.
After replacing batteries in the remote controller
.
ON
OFF
(R1933)
Vue de la page 59
1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 161 162

Commentaires sur ces manuels

Pas de commentaire